Book a Consultation
The underside of a Toyota on the studio lift after coating: gloss black chassis, suspension arms and a coil spring

Car Underbody Coating in Surrey

The part of your car nobody sees. Protected like they do.

Your underbody faces more punishment than any other part of your car. Stone chips, road salt, chemical contamination, moisture and abrasion: relentlessly, every single mile. Feynlab Industrial V2 puts a stop to it.

Coating durability
10yr
From + VAT
£1,000
Detailer. Every job.
1

Most detailers stop at the paint. Paul doesn’t.

A coated wheel arch: coil spring, damper and arch metal in gloss black above the studio floor
After Feynlab Industrial V2

The underbody of a car is its most exposed surface. While paint protection and ceramic coatings preserve the panels everyone can see, the chassis, sills, suspension components and wheel arches are left to absorb everything the road throws at them: unprotected.

Underbody coating changes that. A single application of Feynlab Industrial V2 bonds to metal, plastic and composite surfaces beneath your car, delivering ten years of protection against corrosion, chemical attack, abrasion and moisture ingress.

It reduces cleaning intervals, protects against salt and grime build-up, and preserves the structural integrity of components that are expensive to replace and impossible to ignore once they start to deteriorate.

The product

Feynlab Industrial V2

Feynlab Industrial V2 is a multi-purpose, UV-resistant coating designed for maximum protection across hard surfaces: vehicle underbody, chassis, suspension components, arches, metals and plastics.

As a high-solids, single-component coating, it provides superior resistance to chemicals, abrasion and sun exposure. Extremely hydrophobic, with excellent release properties that prevent contamination from bonding to treated surfaces.

The same product applied to the underside of trains in Norway to prevent snow and ice adhesion. On your car, it means the most exposed surfaces receive the toughest protection Feynlab makes.

  1. I

    10-Year Durability

    A single application lasts a decade. Protection that continues working long after most treatments have worn away.

  2. II

    Chemical Resistance

    Resists road salt, brake fluid, oils, fuel and industrial contaminants. The chemistry that attacks unprotected underbodies cannot penetrate this coating.

  3. III

    Abrasion Resistance

    Stone chips, grit and road debris bounce off rather than scoring the surface. The coating absorbs impact that would otherwise reach bare metal.

  4. IV

    Extreme Hydrophobicity

    Water and contamination bead and release rather than sitting on the surface. The underbody stays cleaner for longer between washes.

  5. V

    UV Resistance

    Plastics and rubbers beneath the car are protected from UV degradation, preserving flexibility and preventing the cracking that accelerates deterioration.

The result

What the coating actually looks like.

  1. Before: a front subframe and sump, dull, grimy and spotted with surface rust
    Before
    After Feynlab Industrial V2: the same subframe and sump, clean and coated in gloss black
    After, same subframe
  2. Before: the whole underbody of a car on the studio lift, grey with road dirt
    Before
    After Feynlab Industrial V2: the same underbody, subframes and arms coated in gloss black
    After, same underbody
  3. Before: a wheel arch, coil spring and damper caked in brown road grime
    Before
    After Feynlab Industrial V2: the same wheel arch clean and coated, the spring and damper black again
    After, same arch
  4. Before: a front hub and suspension arm, dull grey with dirt and surface rust
    Before
    After Feynlab Industrial V2: the same hub and arm coated in gloss black
    After, same hub and arm
  5. Before: a rear subframe and trailing arm, dusty grey metal
    Before
    After Feynlab Industrial V2: the same subframe and arm coated in gloss black
    After, same subframe
  6. Before: a coil spring and lower arm, rusted and grimy
    Before
    After Feynlab Industrial V2: the same spring and arm clean and coated black
    After, same spring and arm
  • A freshly coated wheel arch in gloss black, the bodywork masked off, the brake disc in front
    Wheel arch, freshly coated
  • Close-up of a coated arch, damper and subframe in gloss black behind the brake disc
    Damper and subframe, gloss black
  • The whole coated wheel arch of a red car, masked in plastic sheet, in the studio
    Every surface in the arch covered

What gets protected

Bespoke to every car and every requirement.

  1. I

    Full Underbody

    Complete coverage of the entire underside: chassis rails, floor pan, crossmembers and all structural components. Nothing underneath is left untreated.

  2. II

    Wheel Arches

    The arches take more direct stone chip and abrasion impact than any other part of the car. Coating the inner arches and arch liners dramatically reduces the damage that accumulates over time.

  3. III

    Suspension Components

    Wishbones, subframes, anti-roll bars, brake lines and callipers. Components that are expensive to replace and critical to safety, coated for long-term protection against corrosion and contamination.

  4. IV

    Sills & Shut Lines

    The sills and door shut lines are prime entry points for moisture and corrosion. Coating these areas prevents the trapped water and salt ingress that causes rust to develop unseen.

Why it matters

The case for protecting what you can’t see.

  1. I

    Corrosion Prevention

    Bare metal exposed to road salt, moisture and oxygen corrodes. Once it starts, it spreads. Underbody coating seals metal surfaces from the conditions that cause corrosion before it has a chance to begin.

  2. II

    Residual Value

    A clean, protected underbody is increasingly scrutinised at point of sale, especially on prestige and classic vehicles. A car with a coated, corrosion-free underbody commands higher values and shorter sales periods.

  3. III

    Reduced Maintenance

    Contamination that would otherwise bond to bare metal or plastic releases easily from a coated surface. Cleaning intervals are reduced and the condition of components is maintained for longer between services.

Underside Coating, from

£1,000 + VAT

Price depends on vehicle size, condition and coverage required. Every job is assessed individually. Paul will advise on preparation required and what coverage he recommends.

Book a Consultation

Google Reviews

What clients say about Paul.

5.0

Google rating · 139 reviews

  • “I was thunderstruck by the effect Paul achieved. I am certain the car never looked, or felt, this good, not even the day it came out of the showroom. The depth of the shine has to be seen to be believed. I consider myself very fortunate to have discovered Paul.”
    G Verified customerGoogle review
  • “Paul did an awesome job on my TT and my Q7. The Q7 needed a lot of work and now looks like new. Really worthwhile investment in upgrading and protecting both cars.”
    DW Duncan WalkerAudi TT & Q7
  • “I had my Mercedes paint corrected and ceramic coated and was blown away with how good the work is. The car looks better than brand new. I’ve seen other detailers’ work and they don’t come anywhere close.”
    AH Anjela HitchcockMercedes
  • “Completely blown away by the level of detail and care put into bringing my car back to better than new finish. Paul communicated with video and photos during the whole process. This guy is at the top of his game: he truly knows his craft and has made it an art form.”
    G Verified customerGoogle review
  • “I brought my 12 year old Audi TT to Paul in a sorry state. A week later the transformation was truly miraculous. A deep shine has been restored and the paintwork has a mirror-like finish. He makes the impossible seem possible.”
    WS William SandefordAudi TT
  • “Paul Dalton has been the best known car detailer in this country for many, many years. I was somewhat honoured to partner with him on so many cars of all shapes, sizes and prices. Great guy and still the first call for detailing expertise.”
    S SteveIndustry professional

Book a Consultation

Protect the parts that matter most.

Most people never think about their underbody until something goes wrong. The best time to protect it is before it does.

Paul Dalton

Prefer something quicker? Call Paul.

+44 7444 869983

Your car

The work
What would you like done? *

Photos help Paul see the paint before he calls. You can also send them on WhatsApp.

Your details

So Paul can call or WhatsApp you back.

Best way to reach you

A request, not a booking. No deposit, no call centre. Paul replies himself.